Crawford Cdm9 950 Installation Manual Top May 2026

Always check that the side door switches and spring brake sensor are not sending false "STOP" signals before assuming an electrical fault.

Adjust the unit’s position to ensure it is level and tighten all screws securely.

Connect the operator cables to the Manoeuvring Card inside the control box. Ensure the C-card (main logic) is seated correctly in the lid. Initial Startup: Disconnect power before making any wire changes. Position the door manually about above the ground. Set the SW1 (Installation Switch) to ON . crawford cdm9 950 installation manual top

Hold the Up or Down buttons to move the door and calibrate travel limits.

The features a service lamp and a display for error codes. Always check that the side door switches and

Permanently attach the disengaging label near the manual disengagement knobs. 3. Control Box (ECS 950) Setup

Fit the first stop ring onto the pivot/shaft, then slide the adapter onto the pivot. Ensure the C-card (main logic) is seated correctly

Push the drive unit onto the adapter and fit the second stop ring to secure it.

at input terminals for safety devices like photocells. Use the ECS 950 Service Tool Manual to view specific error logs like .