A cold start is typically only required for major re-configurations or to clear catastrophic memory errors. This involves moving a two-wire jumper to the "Cold Start" position before powering up. 2. Entering the Programming Menu
The display will show a 0 , indicating the unit is ready for a Function Code (FC) or Command Code (CC). 3. Essential Command Codes (CC)
Remove the cover over the CPU PCB to access the configuration switches and jumpers. Gilbarco Sk700 Programming Manual
Identifies the hardware configuration (suction vs. pressure).
Programming is performed using the located inside the dispenser’s head unit. Press the F1 key to initiate the command entry. A cold start is typically only required for
Sets maximum flow rates for different fuel grades (e.g., 40L/min vs 80L/min). Country Code
This article serves as a guide for technicians and site managers on navigating the Gilbarco SK700 Programming Manual Entering the Programming Menu The display will show
, focusing on basic setup, configuration codes, and troubleshooting procedures. 1. Preparing for Programming
Configures the communication method (e.g., Gilbarco 2-Wire, IFSF-Lon). 5. Troubleshooting with Error Codes