If you are working with an and keep seeing the frustrating "Not Connected" or "Link" error, you aren't alone. This is one of the most common issues with both original and clone units. It usually points to a communication breakdown between the hardware and the software.
If your antivirus has deleted the .exe or a .dll file, the program might open but will be unable to "link" to the hardware.
Disable your antivirus, reinstall the software, and add the entire iProg folder to your Exclusion List . 6. Operating System Compatibility iprog programmer not connected link
Here is a comprehensive guide to troubleshooting and fixing the connection issues. 1. Check the Hardware Connection (The Basics)
If you see a yellow exclamation mark or "Unknown Device," the driver is missing. If you are working with an and keep
The iProg software has a built-in feature. This is the best way to determine if the internal circuitry is damaged. Disconnect any adapters from the iProg.
Are you using an or a clone , and which firmware version is currently displayed in your software? If your antivirus has deleted the
Ensure hasn't quarantined the connection files.
The word "Link" often appears when the software cannot verify the of the hardware.
Run the test. If you see "FAIL" on specific voltage lines (like 5V or 12V), a transistor or resistor on the PCB may have blown, requiring a hardware repair. 5. Antivirus and Windows Defender