Manual !!install!!: Moeller Easy512-ac-rc Programming

To connect a contact to a coil, press ALT to activate the line drawing tool. Use the cursor disk to "draw" the connection across the grid.

Used to delete elements or toggle between different circuit symbols and drawing tools.

Before transferring to the hardware, programs can be tested using the offline simulation mode to verify logic without risk to the machine. moeller easy512-ac-rc programming manual

Position the cursor in the first three columns and press OK to select an input (e.g., I1). Use the ALT key to change the contact type to "normally closed" (indicated by an overbar).

The EASY512-AC-RC features a front-mounted LCD and a dedicated keypad for on-site programming without a PC. To connect a contact to a coil, press

To begin programming directly on the device, navigate to the menu and select CIRCUIT DIAGRAM . The workspace consists of up to 128 rungs, with each rung allowing up to 3 contacts and 1 coil.

Coils must always be placed in the far-right fourth column. Press OK and use the cursor to select between standard output relays (Q), markers (M), or specialized function blocks like timers (T) and counters (C). Software Programming with easySoft Before transferring to the hardware, programs can be

The Moeller (now Eaton) EASY512-AC-RC is a foundational intelligent control relay used for small-scale automation in industrial and building environments. This programming manual overview provides the essential steps for local keypad configuration, software-based setup, and basic circuit design.

Internal "helper" relays used to store intermediate logic states or extend a rung if more than 3 contacts are needed.

Confirms selections and enters the main programming menu.