Pax-ii 800 Manual - |work| -

The controller must "learn" the door's width and end positions. Manually push the door to the fully open position and initiate the learn run via the control board's parameter button or an Otis SVT tool. Programming Settings: Enter Menu: Press and hold SET until "P1" is displayed.

When "CL" appears, hold the DOWN button until the door is fully closed, then press SET . Pax-ii 800 Manual -

Ensure the unit is installed in a room that meets local radiation shielding standards. The controller must "learn" the door's width and

The system typically includes a courtesy light that activates during operation and turns off after a few seconds of standby. 2. Pax-i / Pax-ii 800 Dental X-Ray Systems When "CL" appears, hold the DOWN button until

Before powering on, verify all connections to the motor, encoder, and power supply are secure.