Ts1162 Installation Manual [new] Direct

All power should be disconnected from the Challenger panel before wiring the RAS. The TS1162 typically features a pre-wired tail or screw terminals for the following connections: Connection Description

Test the keypad by entering a valid user code to arm/disarm the assigned areas.

The is a 3-LED Remote Arming Station (RAS) designed for use with Challenger security systems. Rated at IP67 , this robust keypad is suitable for both indoor and outdoor installations, including harsh, dusty, or wet environments. ts1162 installation manual

Once physically installed and addressed, the keypad must be enabled within the Challenger system programming: Access the (Default code: 4346 ). Navigate to the RAS Configuration menu. Enable the specific RAS address you assigned to the TS1162.

For further technical support or to download the full PDF documentation, visit the Aritech Support Portal or Ness Corporation . All power should be disconnected from the Challenger

RS-485 data lines for communication with the Challenger panel. Request to Exit (RTE) input for controlling door egress. OUT (Open Collector) A 50mA output used to drive a door relay or door strike.

Use the internal DIP switches (usually 1–4) to set the RAS address (1 through 16). Refer to your specific Challenger panel manual for the binary address table. Rated at IP67 , this robust keypad is

12V DC power from the Challenger LAN or an external power supply.

Use the base as a template to mark screw holes. Use appropriate fasteners for the mounting surface (e.g., wall plugs for masonry). 2. Wiring and Terminals