Disable your internet connection entirely to prevent the clone hardware from locking.
Connect your KTAG tool to confirm the device is detected and functional with version 2.23. :
: Unlocks the ability to read and write modern ECUs that require GPT (Guideline Partition Table) communication. update ktag clone from 225 to 270 exclusive
: This process can take significant time depending on your SD card's write speed. Finalizing with V2.25 : Once the update finishes, close version 2.70.
Launch KSuite 2.25. You should now see the expanded vehicle list and updated protocols (which are often "greyed out" in the 2.70 software for clones) fully active in the 2.25 interface. Disable your internet connection entirely to prevent the
Before starting, ensure you have a KTAG firmware 7.020 device and a folder containing the necessary software versions: KSuite 2.23, 2.25, and 2.70. Preparation and Security :
To update a KTAG clone from firmware 2.25 to 2.70, you must bridge the gap between software stability and protocol expansion. This "exclusive" update allows the device to access 140+ new protocols, including GPT support for modern ECUs, while maintaining the reliability of the 2.25 interface. : This process can take significant time depending
: If the update hangs, consider re-imaging the internal SD card with a higher-quality card to improve read/write stability.
: This typically occurs if you attempt to use KSuite 2.80 drivers or have an active connection that locks the software's car lists.
Open the KSuite 2.70 folder and reinstall the driver while the KTAG is disconnected.